|
Mills,
Lines & Systems
While we
attempt to maintain accuracy, we strongly suggest you contact Acme to determine
if the item(s) you see are still available for sale. We will try to update
monthly, but if you don't see what you are looking for, please contact us. We
may already have what you need, or we can do a global search and find it for
you.
| H096015 |
One (1) Used Bleaching
Line. Manufacturer: Rauma Reploa. Year of Manufacture: 1964 Capacity: 200
ADT/D Fully Bleached Birch Sulphate Pulp
Technical Data: Bleaching
Stages: D/C - EP - H - D Rebuilds:
Chlorination Stage 1989 |
| A098205 |
Used 180-190 TPD coated
board mill for 3 ply 200 - 500 GSM. 2,200 mm (86") machine with 2 coating
lines and size press; 3 stock prep lines; converting line; and cogeneration
4.8 MW by gas. Full equipment list upon request. |
| A097996 |
Used Cotton Linters Pulp
plant. Pulp mill producing bleached pulp from agricultural fibres. Process
uses soda cooking followed by sodium hypochlorite bleaching to a brightness
of about 89 % ISO, producing 20,000 t/year of cotton linter pulp which was
used in the manufacture of specialty and commodity fine papers. Includes:
Intervac dust removal drum, all stainless steel. Drum with perforations has
3.2 m diameter x 2.8 m length, stainless steel body holding the drum and it
is enclosed in a stainless shell width 3.8 m, height 2.8 m and length
2900mm; Tornado stainless pulper, year 1988, batch operation, tub stainless
steel, 2.4 m diameter and 4450mm height, plant ref. 53D149, m/s top cover,
side entry rotor, fed from flat conveyor width 1.5 m and length 11 m, with
pulp lift to first level then to feed conveyor approx. 2 m length at the
inlet level of the pulper; Cutting refiners ref. 53D146 and 43D128. Two
Sprout Waldron, models are R26EM, year 1981, with gearbox and motor drive.
Loading is by gear motor. Starter has a soft start; Sidehill screen
stainless steel with a stainless micro mesh wire, 5 m width x 2.8 m length;
Bauer L.D. cleaners model 606, plastic bodies with ceramic bases. 27
cleaners in total located on the ground floor; Bauer L.D. cleaners, model
606, plastic bodies, ceramic bases, 25 off units; Thune 32L screw press,
stainless 316 body, Hansen gearbox drive from motor; Two Pandia two tube
horizontal digesters, year 1988, ref numbers 53T002 and 53T001. Bodies are
carbon steel sprayed with duplex steel; Horizontal feed screw, stainless
manufacture, safety pressure control valve; Yield 75% on soda cook of cotton
linters feedstock; Dorr Oliver brown stock washer, stainless tubs horizontal
operation, ref. 53D154; Thune 32L screw press, stainless 316 body, Hansen
gearbox drive from motor; Repulper screw in stainless, plant number 53D185,
screw 4000mm length x 400mm approx; Dorr Oliver bleached stock washer,
stainless tub, horizontal operation, ref. 53D141; Bleaching towers, one
f/glass and other stainless. The stainless tower is 2.2m diameter x 9 m
height approx., configured as up-flow with a dilution zone at the top;
Brushing refiners ref. 53D143 and 53D128. Two Sprout Waldron. 1988
manufacture, Models R26-T-F111, gearbox drive from 335kw, 1490 rpm motors,
Gear motor loading. Starter has a soft start; One tank made from titanium
for chemical storage: 3700mm diameter and 3700mm height. (Location in yard)
ref. D64T033and 64T034; Fibre storage one million litre stainless 304L tank.
Tank 52T050. |
| A097817 |
Used 60 ton per day
De-Inking plant for the manufacture of recycled pulp out of waste paper.
Includes primary screening; deinking with 2 Lamort size II Verticells; fine
cleaning; thickening; bleaching; washing screening; and bale production. A
more detailed list is available upon request. |
| A098144 |
Used 75 TPD Deinking
plant consisting of the following: 20m3 Back Clawson high density
Hydrapulper, conveyor, hydrapurge, high density cleaner, slectifier screen,
reject sorter, Ultra low consistency screen, flotation cells, hot dispersion
plant, etc. More specs and photos available. |
| A097340 |
Used 75 TPD deinking plant with 2 deinking cells, 1 mixing tank, pumps, motors, valves, pipes, and instrumentation. |
| A098197 |
Used deinking facility
capable of producing 60 – 70 TPD. Line includes the following: 10 m3
stainless steel helical pulper (1980); Liar-Lamort size 1; Aikawa HD
cleaner; CH-7 screen; S-24A Beloit; vibrating screens; Diablo screen;
tankage; (2) Licar-Lamort deinking cells; separator; (2) drum thickeners;
Flotank; and Beloit 16” series 3000 refiner. Photos available. |
| A097341 |
Used 60 TPD deinking pland made by Escher Wyss. Includes 4 flotation cells, 2 modules with primary and seconday cells. Cell diameter is 2700 mm. 20 diffusers each cell. Working consistency 0.8 -- 1.3%. Cell capacity 12,000 L/mn. |
| A098142 |
Used modern 265 TPD
deinking plant still installed and last used for deinked wet lap pulp. It
can also be used for printing & writing, tissue and newsprint grades. System
includes: pulper, screens, cleaners; flotation cells; water treatment; screw
wash presses; Krima disperser; and more. A complete equipment list and
photos available upon request.
Click to see specs and photos |
| A097631 |
Used plant for fluting
and test liner production, 40 TPD, 2300 mm (90.5") trim, 80-250 gsm.
Includes stock preparation with pulpers, screens, etc. 4 cylinder board
machine with 1125 mm dia vats, 2 staight presses, reverse press, 11 drying
cylinders 1250 mm dia, 4 cylinders 1500 mm dia, 1 MG Yankee 3000 mm diameter
with press roll, pope reel, drives and 2 drum winder. Pumps, controls drives
and boiler available. Electrics were installed in 2001. |
| A097852 |
Used Escher-Wyss hit
dispersion plant with a capacity of 70/80 tpd. Includes Escher Wyss type
SP2C dewatering press, 4-6% consistency in and 25-30% out, 17.5 - 48 meters
per minute and 1100 mm wire width, 11 kW motor. Steam injection heating
barrel. Escher Wyss type HD2 disperger with 400 kW motor, 1500 rpm.
 |
| A097696 |
Used Voith 100 TPD hot
dispersion system. Includes: belt press; transportation screw; inclined
screw; heating screw and HS-100 single shaft disintegrator. |
| XA098186 |
Used paper mill to produce
27,000 TPY of specialty and writing paper 75 – 500 gsm at 240 mpm. Mill
includes: fourdrinier paper machine; stock preparation equipment; machine
shop; sheeter; compressors; lift trucks; laboratory; pulpers; rewinders;
printing machine; baler; and much more. Please request an equipment list,
photos and flow sheet.
Click to see photos and specs |
| H095779 |
Used market sulphite pulp mill designed to produce 420
adtpd. Includes: (7) digesters 17'-3" i.d. x 31' straight shell, 10,000
cu. ft., 165 psi @ 280 degree f.316l clad. (4) brown stock
washers screening bleaching: 5 sequential stages with 5 bleaching
towers and 4 Interstage pulp washers. 166" trim dominion pulp drying machine
with Flakt air dryer produced 300-700 #/3000 sq. ft., 17.5 adtpd @316 fpm.
(500 fpm max.) Machine includes: headbox fourdrinier 2 suction
press sections, 750 pli third press section Flakt air dryer, 21 pass
with booster to produce 90% dry (8) after dryers Lamb cutter/layboy,
conveyors, weighing equipment, press, wrapping, wiring, unitized
|
| A098140 |
Used tissue mill with a
capacity of 10,800 – 12,000 TPY of 100% recycled papers. Mill includes stock
preparation equipment, fourdrinier yankee machine with a capacity of 36 TPD
on papers from 18 – 30 gsm. (Machine built in 1975 with many rebuilds.)
Pasaban rewinder, 2750 mm width with 2 belt unwider and reel lowering table,
3 compressors B&W boiler and water treatment. Mill shut down in December of
2007. A full equipment list is available. |
| A098188 |
Used tissue mill with a
capacity of 75 TPD with:stock prep; Beloit tissue machine with former and
inclined fourdrinier 3300 mm at pope reel, new 1965 yankee cylinder new 1992
and max speed of 1.220 MPM; Accuray system; Jagenberg Vari Du rewinder with
maximum speed of 1.6 MPM and rewind diameter of 1500 mm. Makes tissue and MG
papers 13 - 36 GSM. |
| A097993 |
Used Waste Paper line
producing 25,000 metric tons/year from mixed white waste paper. Line
includes: Beloit Shark pulper; (2) Krebs H.D. cleaners; (2) Finckh Hico
horizontal screens; Finckh vibrating screen; (2) SEPA flotation clarifiers;
Kvaerner SP70L screw press; Albany micro filter screen; GL&V horizontal
careen; Celleco Cleanpac; Beloit Uniflow cleaners; sidehill screen; and
Beloit Polydisc filter. Specs available upon request. |
| A098111 |
Used 125 TPD Modo Mekan
dispersion system with 600 kw drive, including 6 pre thickening screws, 2
Sudor 100 screw presses prior to the heat screw. Photos available. |
| A098072 |
Used 150 TPD Krima
dispersion plant consisting of the following: Cellwood Screw Press Model:
RR550 with its corresponding gearbox and motor of Stainless Steel chute
between the screw press and the Plug Screw; (1) transportscrew Krima 400-4;
(1) transportscrew Krima 400-25º; (1) Cellwood Plug Screw Model: 3823 with
its corresponding gearbox and motor; Cellwood Shredder Model: 400 with its
corresponding gearbox and motor; Cellwood Pre-Heater Model: 10050 with its
corresponding gearbox and motor; Cellwood Infeeder Model: 350 with its
corresponding gearbox and motor; Cellwood Disperser Model KD 710 with its
corresponding gearbox and motor. It includes the disperser hydraulic system
and the lubrication unit. Installed in 1992. Dismantled and stored outside. |
|
